The filters are located in the feedback circuit, which means that the filtering effect increases in intensity with each delay repeat. Low/High Cut sliders and fields: Cut frequencies below the Low Cut value and above the High Cut value to shape the sound of taps (delay repeats) with the highpass and lowpass filters. This affects the behavior of other parameters, such as Flutter and Feedback. Tape Head Mode buttons: Choose Clean or Diffuse mode to emulate a different tape head position. This parameter is not available in mono instances. Spread knob and field: Set the width of the effect signal in stereo instances. That said, aggressive distortion and signal breakup are achieved far more rapidly when a low Clip Threshold level is used. This behavior is influenced by high Feedback values which result in eventual distortion, irrespective of the Clip Threshold value. Lower values result in an aggressive distortion. Higher values produce no additional audible distortion. See LFO and Flutter parameters.Ĭlip Threshold knob: Set the level of the distorted tape saturation signal. Smoothing slider and field: Even out the LFO and flutter effect. Note pop-up menu: Set the grid resolution for the delay time.ĭeviation field: Set the amount of deviation from the grid. : 2 and x 2 buttons: Halve or double the current delay time. Choose a value from the Note pop-up menu to retain the current Deviation value. Note: Clicking note or dot values resets the Deviation parameter value.